Fiberglass Form Ties

Accessories

It couples 400 Series rods. What else do you want to know?

400 Series SWL: 3,000 lbs

Made with custom drawn wire and extra long thread engagement, the coil coupler increases the capacity of the standard 400 Series couplers.

400M Series SWL: 2,250 lbs

Sigma rebar hooks allow easy single sided forming for large foundation pours which greatly reduce the amount of tie length needed.

Please notify appropriate parties that you will be hooking on to the reinforcing cage and that proper precautions have been made to ensure structural integrity of the cage. Consult your individual project engineer before use.

400M Series SWL: 1,500 lbs
400 Series SWL: 3,000 lbs
700 Series SWL: 5,000 lbs

The Sigma Swivel Lag Bolt (SLB) is a 5" x 3/4" lag bolt with our custom coil loop attached to allow a bit of movement when installing the fiberglass tie. The limitation is typically the wood in which the lag bolt is installed into so please consult the appropriate engineering guides when designing with the Sigma SLB.

To install the lag bolt, drill a pilot hole with a 1/2" diameter bit and at least a 4" depth. Use a lubricating film on the threads of the lag bolt to ease installation torque. Do not use the coil loop to install the bolt. Use the hex head.

400M Series SWL: 2,000 lbs
400 Series SWL: 3,000 lbs

Sigma's Cast Wing Nut and Swivel washer have been designed to be used as a single piece and maximize loads using just a single nut. The SWN are designed to be installed like traditional swivel wing nuts so no learning curve or special tools are required.

Safe Working Loads (2:1)
800 Series: 18,000 lbs
1000 Series: 25,000 lbs

Sigma’s water stops are hydrophilic which means they swell and seal when they come into contact with water. A minimum of 3” cover should be used when using Sigma’s water stops to prevent concrete spalling. Sigma water stops are available for all sizes of Sigma Ties. This system is by far the easiest way to install water tight form ties in any waste water or water holding tank application.

The Sigma Tie Saver is the answer to easy stripping of forms and eliminating WASTE in fiberglass tie rod. This product is primarily used on large jobs using aluminum or wood beam and steel stiff back style formwork.